JVC PANDORA KD-X241 - GETTING STARTED; Initial Setup and Configuration

ENGLISH
4
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: “CANCEL DEMO”
“PRESS” “VOLUME KNOB”
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
Set the clock and date
1
Press and hold .
2 Turn the volume knob to select [CLOCK] , then press the knob.
To adjust the clock
3 Turn the volume knob to select [CLOCK ADJUST] , then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Hour
Minute
5 Turn the volume knob to select [CLOCK FORMAT] , then press the
knob.
6 Turn the volume knob to select [12H] or [24H] , then press the knob.
To set the date
7 Turn the volume knob to select [DATE SET] , then press the knob.
8 Turn the volume knob to make the settings, then press the knob.
Day
Month Year
9 Press to exit.
To return to the previous setting item, press .
1
2
Set the basic settings
1
Press and hold .
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press .
Default: XX
SYSTEM
KEY BEEP
ON :Activates the keypress tone.; OFF :Deactivates.
SOURCE SELECT
AM SRC
*
ON :Enables AM in source selection.; OFF :Disables. ( 5)
SW1 SRC
*
ON :Enables SW1 in source selection.; OFF :Disables. ( 5)
SW2 SRC
*
ON :Enables SW2 in source selection.; OFF :Disables. ( 5)
PANDORA SRC
*
(For KD-X241 )
ON :Enables PANDORA in source selection.; OFF :Disables. ( 9)
IHEART SRC
*
(For KD-X241 )
ON :Enables IHEARTRADIO in source selection.; OFF :Disables. ( 10)
BUILT-IN AUX
*
ON :Enables AUX in source selection.; OFF :Disables. ( 11)
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx
YES :Starts upgrading the firmware.;
NO :Cancels (upgrading is not activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
*
Not displayed when the corresponding source is selected.
3
JS_JVC_KD-X241_M_EN_1.indd 4JS_JVC_KD-X241_M_EN_1.indd 4 8/23/2016 11:30:02 AM8/23/2016 11:30:02 AM