EN
To search for a particular passage during playback (track scanning at high speed)
Press and hold the /TUN+ or /TUN- button to scan the current playing track at high speed
until desired passage appears, and then release the button. Playback will start again from this
point.
To select a song which track number exceeds 10 (for MP3 disc only)
To select a song/track which number exceeds 10, press the 10/FOLD./MEM.+ or
10/FOLD./MEM.- button each time to skip forward/backward 10 tracks, then press the
/TUN+ or /TUN- button to select desired track. For example: to select the 17th track, press
10/FOLD./MEM.+ button, and then the /TUN+ button six times immediately.
To Select A Desired Folder (for MP3 disc only)
(if the MP3 disc contains more than one folder)
To skip to the desired folder during playback, press and hold the 10/FOLD./MEM.+ or
10/FOLD./MEM.- button for about 2 seconds to skip to next/previous folder.
PROGRAM TRACKS
Programming tracks of disc are possible when playback is stopped. Up to CD 20 tracks /MP3
99 tracks can be stored in the memory in any order.
1. In stop mode, press the PROG./M/P-MODE button, the “T-000” will flash and the “P01“
indicator will be on.
2. Press the CD /TUN+ or /TUN- button to select the first desired track
to be programmed.
3. Press the PROG./M/P-MODE button to enter. The display changes to show “P02“.
4. Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed.
5. Press the /SELECT/SCAN/PAIR button to start playback from the first programmed
track.
6. Press the /MENU/INFO button to stop program playback.
To Erase the Memory (Program)
To clear the program, you have two options:
1. Press the /MENU/INFO button when the disc is stopped.
2. Open the CD compartment lid, program will be erased.
NOTE: If there are several folders in the USB or MP3 disc , it is necessary to program folders first and
then the tracks. Press the 10/FOLD./MEM.+ or 10/FOLD./MEM.- to select the first folder you want to
program. After that, press /TUN+ or /TUN- button to chose the first desired track to be
programmed, press the PROG./M/P-MODE button to enter. The display changes to show “P02“.
REPEAT
To Repeat a Single Track
1. Press the PROG./M/P-MODE button once in play mode, “REP-1” will show steady on
the display. The current track will be played repeatedly until the /MENU/INFO button is
pressed.
2. To cancel Repeat function, press the PROG./M/P-MODE button until the “REP-1”
disappear on the LCD display.
To repeat all the Tracks
1. Press PROG./M/P-MODE button in play mode till the “REP-ALL” shows steady on the
display, all tracks on the disc will be played repeatedly until the /MENU/INFO button is
pressed.
2. To cancel Repeat function, press the PROG./M/P-MODE button until the “REP-ALL” disa-
ppear on the LCD display.
To Next Page
Loading...
