JVC RC-QC7 - Page 10

(9€00L'ON) O1
One touch operation (COMPU PLAY)
(only when AC power is used)
Even when the power is set to STANDBY, pressing the button shown
below switches on the power and selects the source.
Function mode Operations
cD When this button is pressed with a CD loaded, CD playback begins.
T
T
%
as
=
-
TAPE When this button is pressed with a tape loaded, tape playback begins. |
TUNER When this button is pressed, the tuner is engaged.
T
_
—
7
|
AUX
)
AUX
Asound
source
connected
to
the
AUX
IN
terminal
can
be
engaged.
a
=
is
cee
|
Notes:
@ When switching off the power, be sure to press the (6/1 button.
@ The COMPU PLAY function mode on the remote control has the same
function as that on the main unit.
(|
VOLUME,
TONE
AND
OTHER
CONTROLS
|
VOLUME button
+ : Use to increase the volume.
~ : Use to decrease the volume.
(Control range from VOL 0 to VOL 25.)
nO
VOLUME
ACTIVE HYPER-BASS PRO button
ON : The ACTIVE HYPER-BASS PRO indicator lights up. Set ta this
position to activate ACTIVE HYPER-BASS PRO sound.
OFF: The ACTIVE HYPER-BASS PRO indicator goes out. Set to this
position when ACTIVE HYPER-BASS PRO sound is not required.
10
Sound mode button
Sound modes canbe selected to enhance the type of music being played.
© Press the SOUND button to select the sound mode.
@ Each time the SOUND button is pressed the sound mode changes as
follows:
‘SOUND
A
BEAT —> POP —> CLEAR -® FLAT
Sound mode selection
BEAT:
Set to this position for music with a heavy beat, such as rock or disco
music.
PoP:
Set to this position for light music including popular and vocal music.
CLEAR:
Set to this position for crisp and clear sounding music with transparent
highs.
FLAT (No sound effect (flat characteristics)):
Set to this position when listening to classical music.
Note:
The selected modes only affect the sound output from the speakers or
headphones. They do not affect the sound when recording.
(| HANDLING CDs
Since dirty, damaged and warped COs may damage the unit, take care
regarding the following:
1. Usable CDs
Use CDs with the mark shown.
2. Notes on handling CDs
© Do not touch the reflective recorded surface.
3. Storage
® After removing a CD from the unit, be sure to put it back in its case.
® Do not expose CDs to direct sunlight, high temperatures from a
heater, etc., high humidity, or dust.
4. Cleaning COs
© Before loading a CD, wipe off any dust, dirt or fingerprints with a
soit cloth. CDs should be cleaned by wiping radially from the center
©
Do
not
stick
or
write
anything
on
the
label
side.
to
the
edge.
@
Do
not bend
CDs.
@
Never
use
thinner,
benzine,
record
cleaner
or
antistatic
spray.
©
Removing
the
CD
from
its
storage
case
and
loading
it
®
Handling
St
ineoiwe
DIGITAL
AUDIO
@
Cleaning
Correct
Incorrect
© Press
to
secure
the
CD.
Note:
CDs
shaped
like
a
heart,
flower,
etc.
(specially-shaped
CDs)
can
not
be
used
with
this
unit.
If
this
type
of
CD
is
loaded,
it
will
cause
a
trouble.
"i
| 5/N3/3/a Z9D0-9H