JVC RC-QC7 User Manual

@ Set the stop time.
(Example: To set the timer stop time to 13:15.)
\ a 7/ TIMER
EW
———
MULT
CONTROL
——~_
FF
;
®@
Press
to
set
the
timer
off
time.
>
AFIS
-
R
Sf
4
\
Prime
D>
-TUNER-
a
\|
\
@ Select the TIMER mode.
© The selected timer mode is shown in the display.
‘When the b> button is pressed to selact the timer mode, the mode changes from TUNER (timer reception of
a broadcast), to TUNER/REC (timer recording of a broadcast}, to CD (timer play of a CD), to TAPE (timer
Playback of a tape), in this order.
POLS
a are
@ Set the volume.
cy
VOL--
—~
vol
O—
vol
te
¥OLaS
7
BS
girs
-f-
This
shows
when
volume
level
1
is
selected.
7
! '
v
|
7
TIMER
Q
>
he
©
The
unit
enters
the
previously
engaged
mode
and
timer
setting
has
been
completed.
(The
(®)
indicator
tights.)
® When the volume setting is set to “VOL --" (volume tevel is not specified), Note:
the
timer
playback
volume
is
at
the
level
used
before
setting
the
timer.
@
When
the
timer
is
set
incorrectly
or
the
correct
mode
is
not
selected,
perform “Setting the timer” from the beginning.
©
To
confirm
the
timer
setting
sg
pegs
1. Each time the TIMER button is pressed, the timer setting can be
confirmed.
2. When the previously engaged mode is displayed, timer setting has
been completed.
Zt (9€001'0ON)
Timer recording of broadcast
© The current time must be set before the timer can be used.
© Make sure that the safety tabs of the cassette have not been broken
off.
° :
@ Set the 6/1 button to ON.
@ Load a cassette in Deck B.
© Insert the cassette with the side to be recorded facing up.
© Select the required reverse mode (= or <7).
@ Set the timer. (Refer to “Setting the timer” on page 23.)
© Set the timer about a minute before the broadcast to be recorded is
scheduled to start.
Fe Se be scaeet {Refer to page 18.)
Set the 6/1 button to STANDBY.
© Timer recording will start at timer start time and the power will be
Switched off at timer stop time. (The timer mode is then released.)
® To cancel timer operation
Press the TIMER button so that the timer mode indicator (©) goes out.
if you do this, timer recording will not start at the timer start time.
Mer.
Notes:
Once the timer has been set, the start and stop times, etc., are stored in
memory. When timer recording or playback is required at different times,
the timer must be set again.
© After setting the timer start and stop times, check that the tuner is tuned
to the required frequency.
@ When the power cord is disconnected for more than 2 minutes or there
is a power failure lasting more than 2 minutes, timer settings will be
erased from memory. If this happens, set the current time and perform
the timer setting again.
Timer playback
© Timer playback of tapes, broadcasts and CDs is possible.
Operations
«ERR
@ Set the d/Ibutton to ON.
@ Set the timer. (Refer to “Setting the timer” on page 23.)
Source sound Timer mode Operations
CD play cD Load a CD.
Tape playback TAPE Load a cassette tape.
Tune to the required station.
| Broadcast TUNER
© Set the 6/1 button to STANDBY.
© Timer piayback will start at the timer start time and the power will be
switched off at the timer stop time.
The unit remains in the same timer mode even aiter the power is
switched off. The same timer function will repeat at the same time on
the following day.
© When the timer mode is activated, the “®” indicator biinks.
© When the power is switched on, it is possible to fade in the sound from
volume lavet 0 (zero) to the preset volume.
© To cancel timer operation
Press the TIMER button so that the timer mode indicator (©) goes out.
25
)/N3/a/a 290-0uY

JVC RC-QC7 Specifications

General

Brand	JVC
Model	RC-QC7
Category	CD Player
Language	English