JVC SP-AD70-B - Advanced Troubleshooting; Connectivity and Unit Freezing Solutions

23
Problem Solution
I cannot nd “SP-
AD70-A” or “SP-AD70-B”
on my Bluetooth® device.
• Ensure that the unit is switched on.
• Ensure that the Bluetooth® function is activated on your Bluetooth® device.
• The unit has a Bluetooth® function that can receive a signal within 10 metres. Keep a distance
within 10 metres between the unit and your Bluetooth® device.
Voice interrupted in
Bluetooth® mode.
• Ensure that the unit and Bluetooth® device is connected within 10 metres.
• Ensure that no obstruction between the unit and the Bluetooth® device.
NFC Pairing failed. • Ensure that the Bluetooth® device supports NFC function.
• Ensure that the unit is in pairing mode.
• For rst time pairing, ensure that the Bluetooth® device touches NFC sensor of the unit.
• Remove mobile phone protection shell for NFC pairing.
No Sound in
AUX mode.
• Ensure the audio cable is properly connected.
The unit does not
respond when pressing
any buttons.
• The unit may freeze up during use. Switch the unit o and then on again to reset the unit.
• Press the reset button, and then press button on the unit again.
SP-AD70-A_B_IB_Final180717V5.indd 23 30/7/2018 11:04 AM