JVC SP-PWA85 - Page 128

References
59
English
%
Center unit (XV-THA55)
Audio section
Total Harmonic Distortion 0.01 %
NOTE: This value is measured at System cord CONNECTOR for
reference.
Audio input sensitivity/Impedance (at 1 kHz)
Analog input:
AUDIO IN VCR: 360 mV/47 kC
Digital input*:
DIGITAL IN (DBS): –21 dBm to –15 dBm
(OPTICAL) (660 nm E30 nm)
* Corresponding to Linear PCM, Dolby Digital, and DTS Digital
Surround (with sampling frequency — 32 kHz, 44.1 kHz, 48 kHz)
Video section
Color System: NTSC/PAL selectable
Horizontal Resolution: 500 lines
Signal-to-Noise Ratio: 64 dB
Video output level
Composite: 1.0 V(p-p)/75 C
S-video-Y: 1.0 V(p-p)/75 C
S-video-C: 0.286 V(p-p)/75 C
Component-Y: 1.0 V(p-p)/75 C
Component-P
B
/P
R
: 0.7 V(p-p)/75 C
Video input sensitivity/Impedance (VCR IN)
Composite: 1.0 V(p-p)/75 C
S-video-Y: 1.0 V(p-p)/75 C
S-video-C: 0.286 V(p-p)/75 C
Tuner section
Tuning Range
FM: 87.50 MHz to 108.00 MHz
AM: 531 kHz to 1 602 kHz
(at 9 kHz intervals)
530 kHz to 1 600 kHz
(at 10 kHz intervals)
General
Power Requirements: AC 110 – 230 V
Ó
,
50 Hz/60 Hz
Power Consumption: 20 W (at operation)
2.5 W (in standby mode)
Dimensions (W
M
H
M
D):398 mm
M
70 mm
M
265 mm
Mass: 2.7 kg
%
Subwoofer (SP-PWA55)
Amplifier section
Front/Center/Surround: 80 W per channel, RMS at 6 C at
1 kHz, with 10 % total harmonic
distortion.
Subwoofer: 120 W, RMS at 4 C at 100 Hz, with
10 % total harmonic distortion.
Speaker section
Speaker unit: 20 cm Bass-reflex, Magnetically
Shielded
Frequency Range: 25 Hz to 200 Hz
General
Power Requirements: AC 110 V/127 V/220 – 230 V
Ó
selectable with the voltage selector,
50 Hz/60 Hz
Power Consumption: 150 W (at operation)
0 W (in standby mode)
Dimensions (W
M
H
M
D):235 mm
M
355 mm
M
492 mm
Mass: 13.0 kg
Specifications
TH-A55[UW]-11Spec.fm Page 59 Friday, June 13, 2003 9:13 AM