English
ENGLISH
– 8 –
Connections
Before connecting this unit to the amplifier (or receiver), observe
the following carefully.
•Turn off the amplifier.
• Make all connections before plugging in this unit.
• DO NOT connect this unit to the REC OUT jacks of your
amplifier. It may damage your subwoofer.
Operations
Power lamp
Rear view
Turning On the Power—POWER
To turn on the power.
Press the POWER switch to the [ ❙ or
] ON position.
• The power lamp lights in green.
SP-PWE5 SP-DWF10
ON OFF
POWER
To cut of the power.
Press the POWER switch to the [ ‡ or
] OFF position.
• The power lamp goes out.
• This will disconnect the mains lead.
SP-PWE5 SP-DWF10
ON OFF
POWER
Operating the Unit Automatically According to the Incoming
Signals—AUTO POWER ON/STANDBY
To activate AUTO POWER ON/STANDBY.
Press the AUTO POWER ON/STANDBY switch to the [
] ON
position.
• If no sound comes in for 5-10 minutes, the unit enters
standby mode. The power lamp lights in red.
• If the unit detects incoming signals, the unit starts
operating. The power lamp lights in green.
To cancel AUTO POWER ON/STANDBY.
Press out the AUTO POWER ON/STANDBY switch to set it to the
[
] CANCEL position.
CANCEL
ON
AUTO POWER ON / STANDBY
SP-PWE5 (Front) SP-DWF10 (Front)
To LINE OUT
Amplifier or Receiver
Monaural audio cord (Supplied)
To SUBWOOFER OUT
or MONO
Stereo audio cord (not Supplied)
SP-PWE5
SP-DWF10
In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal.
SP-PWE5 (Rear) SP-DWF10 (Rear)
Power lamp
To an AC outlet
To an AC outlet
When the volume level of the amplifier is so low or the
incoming signals are so weak that this unit cannot detect
sounds, Auto Power On/Standby may not work correctly.
SP-DWF10_EN.pm65 04.1.30, 4:42 PM8
To Next Page
Loading...
Need help?
General
