Operating external components with the remote control
12
7 To set the manufacturer’s code
1 Slide the remote control mode selector
to VCR.
2 Press and hold VCR.
Keep the button pressed until step 4 is finished.
3 Press ENTER.
4 Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).
Examples:
For a Panasonic VCR:
Press 2, then 1.
For an Philips VCR:
Press 0, then 5.
5 Release VCR.
If there is more than one code listed for your brand, try each
one until you enter the correct one.
7 Operation
Aim the remote control at the VCR.
IMPORTANT
Before using the remote control to operate a VCR;
Set the remote control mode selector to VCR.
The following buttons are available:
VCR:Turns VCR on and off.
3 (play button):Starts playback.
7:Stops operation.
8:Pauses playback.
¡:Fast forwards video tape.
1:Rewinds video tape.
REC:Press this button together with 3 (play button) to start
recording or together with 8 to pause recording.
CHANNEL +/–:Changes the TV channels on the VCR.
Operating the VCR
Manufac-
turer
Code
Manufac-
turer
Code
JVC 01 Nokia 16
Aiwa 02, 20 Nordmende 17 – 19, 31
Bell+Howell 03, 16 Orion 20
Blaupunkt 04 Panasonic 21
CGM 03, 05, 16 Philips 05, 22
Daewoo 34 Phonola 05
Digtal 05 Saba 17 – 19, 23, 31
Fisher 03, 16 Samsung 24, 25
G.E. 06 Sanyo 03, 16
Grundig 07 Sharp 26, 27
Hitachi 08, 09 Siemens 07
Loewe 05, 10, 11 Sony 28 – 30, 35
Magnavox 04, 05 Telefunken 17 – 19, 31, 32
Mitsubishi 12 – 15 Toshiba 33
VCR
See page 11 for button locations.
TH-S1[B]-2.book Page 12 Monday, May 31, 2004 10:45 AM
To Next Page
Loading...