JVC TH-M505 - Powered subwoofer

(No.MB192)1-9
3.1.3 Removing the DVD changer mechanism assembly
(See Fig.7)
• Prior to performing the following procedures, remove metal
cover and front panel assembly.
(1) From the top side of the main body, disconnect the card
wires from the connectors (CN401
to CN403) on the main
board.
Reference:
When connecting the card wires, connect them to the
connectors (CN401
to CN403) on the main board after
passing the card wires through the hole d on the main
board.
(2) Remove the four screws E attaching the DVD changer
mechanism assembly on the bottom chassis.
(3) Take out the DVD changer mechanism assembly in the up-
ward direction.
Reference:
When attaching the DVD changer mechanism assembly, align
the holes of the DVD changer mechanism assembly to the pro-
jections e on the bottom chassis.
Fig.7
3.1.4 Removing the rear panel
(See Fig.8)
• Prior to performing the following procedures, remove the metal
cover.
(1) From the back side of the main body, remove the screw F
and twelve screws G attaching the rear panel.
Fig.8
Main board
CN402
Bottom chassis
DVD changer mechanism assembly
Card wires
E
E
E
Projections e
Hole d
CN401
CN403
FG
G
Rear panel