(No.MB421)1-21
A tray lock is completed.
Press the "STOP" and "OPEN/CLOSE1" keys
on the remote controller at standby.
Insert the power cord in an outlet while
pressing the "POWER
"
and "PAUSE" keys
on the main unit simultaneously.
A main unit entered in the
NTSC mode compulsively.
5.FORCED NTSC MODE
It is made compulsive NTSC mode.
From this, with regards to the input of NTSEL_SW, there is nothing only
at the time of 1st power on, and it performs NTSC starting.
(Command specification is performed to a module.)
A mode clearance is performed by power off.
VIDEO FORMAT change is prohibited during Forced NTSC mode.
6.TRAY LOCK
A loader mechanism's tray lock is carried out. In the tray lock function ON state,
EJECT processing is not performed to the EJECT key.
And , a LOCK display is performed at this time.
When it turns off a tray lock function, STOP and EJECT KEY are pushed simultaneously again.
Back up ON/OFF of a tray lock.
7.TUNER AM 9k STEP SW (only U version)
AM frequency is changed with 9k STEP.
8.TUNER AM 10k STEP SW (only U version)
AM frequency is changed with 10k STEP.
Press the "STOP" and "PLAY" keys on
the main unit simultaneously.
A tuner unit entered in the
9k step mode.
Press the "STOP" and "PAUSE" keys on
the main unit simultaneously.
A tuner unit entered in the
10k step mode.
To Next Page
Loading...
