JVC UX-A4 - Skip playback; Direct access playback (using the remote control); Search playback

UX-A4 B/E/G/GI/EN |
@ Hold down the button; search play starts slowly and
then gradually increases In speed.
@ Since low-volume sound (at about one quarter of the
normal level) can be heard in the search mode, monitor
Notes:
© The following indication may be shown when a disc Is
dirty or scratched, or when the disc is loaded upside
down.
In
such
a
case,
check
the
disc
and
Insert
again
after
the
sound
and
release
the
button
when
the
required
cleaning the disc or turning it over. position is located.
Direct access playback (using the remote
control)
@ Pressing any of the track number buttons will start play
fon the beginning of the designated tune, without your
© Do not use the unlt at excessive high or cold aving to press the CD »/ml button. (This function
temperatures.
The
recommended
temperature
cannot
be
used
during
programmed
play.)
range Is from 5°C (41°F) to 35°C (95°F).
® After playback, unload the disc and close the CD door.
if mistracking occurs during play, lower the volume. Oo
® Mistracking may occur if a strong shock fs applied to the
unit or if is used in a place subject to vibrations (1.e. Ina
car travelling on a rough road).
cco)
RIGLEAR e---—---->-]
t
Skip playback
e During playback, it Is possible to skip forward to the
beginning of the next tune or back to the beginning of
the tune being played or the previous tune; when the
beginning of the required tune has been located, play
starts automatically.
To listen to the next tune ...
Press the pti button once to skip to the beginning of the
next tune.
ge eee @ Press the m/CLEAR button to set to the CD mode.
e esi the required tune using the track number
uttons,
© To designate tune numbers 1 to 10, press the track
number button corresponding to the tune (track)
number.
© To designate tune number 11 or higher, press the
+10 button the required number of times, then the
track number button. (Example: To designate the
20th tune, press the +10 button once, then press
track number button 10.)
* +10 button:
De ei Each time this button Is pressed, the number Increases
by 10. First press this button to set the 10's digit, then
press the track number button to set the 1's digit.
To listen to the previous tune ...
Press the mé<@ button to skip to the beginning of the tune
being played back and press again to skip to the beginning
of the previous tune.
¢@ To skip to another tune during play
When the required track number button is pressed, the
display shows the designated track number and play
Starts from the beginning of the designated tune.
Search playback
(to locate the required position on the disc)
® The required position can be located using fast-forward
or reverse search while playing a disc.
CO/ TUNING
sed
Keep pressing for fast-reverse search Keep pressing for fast-forward search
DOWN UP
12 (No. 1890)