JVC UX-A4 - Programmed play (using the remote control)

Pr
@ Ga
ogrammed play (using the remote control)
Up to 20 tunes can be programmed to be played in any
required order.
The
total
playing
time
of
programmed
tunes
is
displayed
(up
to
99
minutes,
59
seconds).
(Example: When programming the 2nd tune to be played
first, the 6th tune next, and then the 12th tune, etc.)
UX-A4 B/E/G/GI/EN
@ 7
cama > [Sa
To designate the 2nd tune.
Press the M/CLEAR button.
Press the PROGRAM button while pressing the SHIFT
button to set to the programming mode.
Press to designate the required track number.
Designate the remaining tunes by pressing the track
number buttons.
© Press the P/H button when programming is
completed. Programmed playback starts.
To clear the programmed tunes ...
Press the m/CLEAR button before playing a disc. During
programmed playback, press this button twice. When the
CD door is opened, programmed tunes are cleared
automatically.
The total playback time of programmed tunes is
displayed.
The 12th tune
To confirm the datalls of a program...
Press the PROGRAM button while pressing the SHIFT
button; the tunes making up the program will be displayed
In programmed order.
Notes:
1.
If the total playing time of the programmed tunes
exceeds 99 minutes 59 seconds, the total playing time
indication will go out.
Programming 21 or more tunes is impossible.
. When a disc with 16 or more tunes Is loaded, the
“OVER* indicator will appear.
When a track number that Is higher than 21 Is
programmed for a disc which contains more than 21
tunes, the track No. Is displayed, however, “~ —:- -" Is
shown in the total playback time.
When performing timer playback In the order of
"Programmed play”, step @ above Is not required.
7
Qo
SHIFT
Tune number Program order number
(No. 1890) 13