JVC UX-A4 - Music scan; RADIO RECEPTION; FM MODE button; Seek tuning

Music scan
e
The
beginning
of
the
current
tune
or
the
next
tune
can
be
located
using
the
music
scan
facility.
Press the & or <J button for tape playback.
Press the »P or <td bution for music scan.
@ To the start of the next tune
>>
(Forward
(C>)
direction
playback)
O
<«<
(Reverse
(<i
direction
playback)
O
( RADIO RECEPTION
Operate in the order shown
UX-A4 B/E/G/GI/EN
@® When music scanning Is completed, playback will start
automatically.
e To rae two tunes or more, repeat the above steps @
and @).
Notes:
With the following types of tape, the Music Scan
mechanism may not operate correctly. This Is not a
malfunction; use the Music Scan facility only with suitable
tapes.
e Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portion during tunes.
e Tapes with short non-recorded sections.
e Tapes with high-level noise or hum between tunes.
© To the start of the tune being played back
<«<
>>
©
The tape direction indicators blinks during
music scanning.
@ Press the TUNER/BAND button.
e The power Is switched on and a band and radio
frequency will be shown in the display.
@ Select the band (FM or AM (MW/LW)).
© Tune to the required station.
FM MODE button
AUTO:
Set to this posilion when listening to or recording an FM
stereo broadcast. The STEREO indicator lights when the
FM stereo broadcast is received.
MONO:
Set to this position when FM stereo reception is noisy.
e Seek tuning
Press the UP or DOWN button for one second or more;
the unit enters the seek tuning mode and tunes to
higher or lower frequencies, and when the broadcast Is
received, it stops tuning automatically and the
broadcast can be heard.
In
AM
operation,
the
frequency
moves
continuously
from
the
MW
to
the
LW
band
and
vice
versa.
(No. 1890) 15