JVC UX-A4 - Auto preset tuning; Manual tuning; Presetting stations; Using the antennas

UX-A4 B/E/G/GI/EN
Press to move to lower frequencies
Auto preset tuning
(using the remote control unit)
This function scans the current band (FM or AM (MW/LW)),
detecting frequencies used to broadcast signals, and
stores the first 15 frequencies In memory automatically.
e Press the AUTO PRESET button. The frequencies of
stations broadcasting signals can be preset
automatically in the order of increasing frequency.(15
stations in each band (FM and AM (MW/LW)).
Preset tuning (using the remote control unit)
Press the TUNER/BAND button
Select the band (FM or AM (MW/LW)) using the
TUNER/BAND button.
@ Press the required preset station buttons (No.1
—No.10, +10).
© The preset station number and frequency corresponding
to the button pressed are shown.
Using the antennas
FM: Connect the provided FM feeder antenna
(see page 7).
AM (MWI/LW): Adjust the position of AM (MW/LW)
loop antenna.
16 (No. 1890)
e Manual tuning
Each time the UP or DOWN button is pressed, the unit
Steps through the current frequency band. Tuning Is in
steps of 50 kHz for FM and 9 kHz for AM (MW/LW).
In AM operation, the frequency moves continuously
from the MW (522 - 1,629 kHz) to the LW (144 - 288 kHz)
band and vice versa.
CD / TUNING
Press to move to higher frequency
DOWN UP
Notes:
@ When seek tuning to the required station is not possible
because It Is broadcasting too weak a signal, press the
UP or DOWN button momentarily to perform manual
tuning.
e When the power is set to STANDBY, or another mode
(TAPE or CD) is selected, the last tuned frequency is
stored in memory. When the power is switched on again
and TUNER/BAND buiton is pressed, the same station
will be heard,
Presetting stations
(using the remote control unit)
15 stations in each band (FM and AM (MW/LW)) can be
preset as follows:
e Example (when presetting an FM station broadcasting at
103.5 MHz to preset button °15°)
@ Press the TUNER/BAND button.
© Select the FM band using the TUNER/BAND button.
© Tune to the required station.
© Press preset button °+10°, then "5" for more than 2 sec.
(When “15° blinks In the preset station display, the
Station has been preset.)
e Repeat the above procedure for each of the other
stations, using a different preset button each time.
@ Repeat the above procedure for the AM (MW/LW) beand.
e To change preset stations
Perform step @ above after tuning to the required
station.
Notes:
e The previous preset station is erased when @ new
station is set as the new station's frequency repzices
the previous frequency in memory.
e When listening to an AM (MW/LW) broadcast, nois; may
be heard if the remote control is used.
© All preset stations will be erased when the power cord is
disconnected or a power failure occurs for more than 24
hours. In such cases, preset them agaln.