JVC UX-A4 - Set the stop time; Select the TIMER mode; Set the volume

© Set the stop time
(Example: when the timer stop time is set to 13:15.)
@ Adjust the hours.
CO / TUNING
hed
© Select the TIMER mode.
cD
4 ENTER
ee! TUNING Le ie
= aper
oO TUNER
Blinks
yo. ¢
@ Sat the volume.
CD/ TUNING for
ss V ut /
O This shows when volume level 1 is selected.
The playback level Is determined by the position of
VOLUME control.
vou - vol vO
———
The volume decreases to zero at the timer start
time, and the sound fades in.
© The unit enter the previously engaged mode and timer
Setting is complete.
® To check the timer setting
1. Press the TIMER button.
2. Press the ENTER button to check the timer mode.
3. When the previous engaged mode Is displayed, timer
Setting has been completed.
CD f TUNING
>t
— = it Ui
UX-A4 B/E/G/GI/EN
@® Adjust the minutes.
ENTER
OFF Blinks
e Press to set the timer off time.
© The selected timer mode is shown in the display.
When the UP button Is pressed to select the timer
mode, the mode changes from the, CD (timer
playback of a CD), TAPE (timer playback of a tape),
TUNER (timer reception of a broadcast) to
TUNER/REC (timer recording of a broadcasi), In
this order.
> 6
© The selected volume is set.
When the UP button is used to select the volume.
f {
q} i
Notes:
@ When the timer Is set incorrectly or the correct mode Is
not selected, perform “Setting the timer" from the
beginning.
@ When the timer is set, "-:--" in the display is replaced by
the Input digits.
e@
When
the
timer
stop
time
is
not
set,
the
timer
operates
for
2
hours
and
then
the
unit
is
switched
off.
To
continue
listening
after
the
timer
stop
time,
display
the
timer
stop
time,
change
the
hours
digits
to
*-:"
using
the
UP
button
and
press
the
ENTER
button.
(No. 1890) 21