JVC UX-A4 - TIMER OPERATIONS; Timer recording of broadcast; Timer playback

UX-A4 B/E/G/GI/EN |
( TIMER OPERATIONS
Timer recording of broadcast
e The current time must be set correctly before you set
timer recording.
e Make sure that the erase protection tabs of the
cassette have not been broken off.
Operations
1. Set the POWER button to ON.
2. Load a cassette.
e Insert the cassette with the side to be recorded
facing out.
@ Set the reverse mode buttonto” 23> “or” =
and set the DOLBY NR button as required.
3. Set the timer start and stop times, set the timer
tecording mode, then set the required volume, in this
order. (Refer to “Setting the timer” on page 46.)
© Set the timer about a minute before the broadcast to
be recorded Is scheduled to start.
4. Tune to the station to be recorded. (Refer to page 34.)
5. Set the POWER button to STANDBY.
Timer playback
© Timer playback of tapes, broadcasts and CDs Is
possible.
Operations
© Set the POWER switch to ON.
@ Set the timer start and stop times, set the timer
playback mode, then set the volume, in this order.
(Refer to “Setting the timer" on page 46.)
© Timer playback of a CD is possible in programmed
order. (See page 27.)
® The volume can be set to 50 different levels.
© Tune to the required frequency when the timer playback
of a broadcast is 1o be performed.
© Switch the power off.
e Timer playback will start at the timer start time and the
power will be switched off at the timer stop time.
The unit remains In the same timer mode even after the
power is switched off and the same timer function will be
repeated at the same time on the following day.
22 (No. 1890)
TAPE
basis inp ipa Loe | me ee =
e Timer recording will start at preset start time and
the power willl be switched off at preset stop time.
When timer recording is completed, the timer mode is
switched to the "TUNER" (timer reception of broadcast)
mode.
@ To cancel timer operation
Press the TIMER button so that the timer mode Indicator
( © ) goes out.
If you do this, timer recording will not start at the timer start
time.
Notes:
Once the timer has been set, the start and stop times,
etc., are stored in memory. When timer recording or
playback is required at different times, the timer must be
set again.
e After setting the timer start and stop times, check that
the unit is tuned to the required frequency.
@ When the power cord is disconnected or there Is a power
failure, timer settings will be erased from memory. If this
happens, set the current time and perform the timer
setting again.