JVC UX-A4 - REMOTE CONTROL UNIT; Preparation before use; Using the remote control unit

UX-A4 B/E/G/GI/EN
8
Clock/Timer section
@ Display window
Timer mode indicator
SLEEP indicator
Timer indicator (ON/OFF)
@® Time display
@ UP/DOWN bultons
Set the time or timer setting.
© CLOCK button
Set the time and current time displays.
@ TIMER button
Set the timer setting or timer ON/OFF (to reset or
cancel the timer).
@ ENTER bution
Register the time or timer seiting.
( REMOTE CONTROL UNIT
Preparation before use
3. Replace the cover,
@ Installing batteries In the remote control unit
1. Remove the battery cover from the back of the remote e Battery replacement
control unit, When the remote control operation becomes unstable
2. Insert two °R6" size batteries. or the distance from which remote control is possible
@ insert the batteries with the @® and © terminals becomes shorter, replace the batteries with new ones.
matching the indication inside the battery
compartment.
S Insert theO ends first.
S A
c> WZ a HF
Y
Using the remote control unit
To use the remote control unit, point it at the REMOTE
SENSOR and press the buttons gently and firmly. Remote
control operation is possible within about 7 m (approx. 23
ft). However, since the remote control range Is less when
the unit is used at an angle, use directly in front of the
REMOTE SENSOR, as far much possible.
Do not expose the REMOTE SENSOR to strong light (direct
sunlight or artificial lighting) and make sure that there are
no obstacles between the REMOTE SENSOR and the
semote control unit.
(No. 1890)