EasyManua.ls Logo

JVC UX-A52

JVC UX-A52
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
English
To stop during play, press 7.
To fast-wind or rewind the tape, press ¢ or 4.
When the tape direction is
¢ : Fast-winds the tape.
4 : Rewinds the tape.
When the tape direction is
4 : Fast-winds the tape.
¢ : Rewinds the tape.
To eject the cassette, press TAPE open/close 0.
After ejecting the cassette, press TAPE open/close 0
again to close the electronic swing panel.
DO NOT press TAPE open/close 0 during tape play.
To play both sidesReverse Mode
You can set the cassette deck to play just one side of a tape,
both sides once, or both sides continuously.
You can set this mode only when a cassette is already in
the cassette deck.
On the remote control ONLY:
Press REV. MODE.
Each time you press the button, the reverse mode
changes as follows:
: To only play back one side (front or reverse.)
: To play back the front and reverse sides once.
: To play back both front and reverse sides
continuously.
To check the clock time while playing back a tape
On the remote control ONLY:
Press DISPLAY (not on number buttons.)
Each time you press the button, the source information
and the clock time alternate on the display.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.
Playing Back a Tape
You can play back type I, II, and IV tapes.
1
Press TAPE open/close 0 on the unit.
The unit automatically turns on, the electronic swing
panel slides downward, and the cassette loading slot
appears.
If a cassette is already in the cassette loading slot, it is
ejected.
2
Insert a cassette with the exposed part facing left.
The cassette is pulled in, then the electronic swing
panel slides upward automatically.
3
Press TAPE 2 3.
The tape starts playing.
Each time you press the button, the tape direction
changes as follows:
: Plays the front side.
: Plays the reverse side.
Reverse mode
Tape direction
Tape indicator
When the tape plays to the end, the cassette deck
automatically stops if the reverse mode is set to
or
. (See To play both sidesReverse Mode.)
cassette loading slot
EN22-25UX-A52[UNUSUJ]_f 01.12.21, 21:1823

Table of Contents

Related product manuals