EasyManua.ls Logo

JVC UX-A70MDR - Getting Started; Unpacking; Connecting Antennas

JVC UX-A70MDR
55 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 6 –
Getting Started
Unpacking
After unpacking, check to be sure that you have all the
following items.
The number in the parenthesis indicates the quantity of the
pieces supplied.
FM antenna (1)
AM (MW/LW) loop antenna (1)
AC power cord (1)
Remote control (1)
Batteries (2)
Spacers (2)
If any is missing, consult your dealer immediately.
Connecting Antennas
FM antenna
1
Attach the FM antenna to the FM (75 ) COAXIAL
terminal.
2
Extend the FM antenna.
3
Fasten it up in the position which gives you the best
reception.
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
FM antenna (supplied)
Outdoor FM antenna
(not supplied)
A 75 antenna with coaxial type
connector (DIN 45325) should be used.
To connect an outdoor FM antenna
Before connecting it, disconnect the supplied FM antenna.
Continued
EN01-09.UX-A70MDR[B]_f 00.12.4, 10:59 AM6

Table of Contents

Related product manuals