JVC UX-G100 - Setting the Clock; Turning Off the Power Automatically-Sleep Timer

12
Setting the Clock
Set the clock before using the Daily Timer (see page 20).
• You can set the clock only when the System is turned off
(on standby).
1 Turn off (standby) the System.
2 Activate the clock setting mode.
3 Adjust the hour.
4 Adjust the minute.
The built-in clock starts working.
To check the current time during play
The time is displayed for a few seconds.
If there is a power failure
The clock loses its settings and “0:00” flashes. You need to
set the clock again.
Turning Off the Power Automatically
—Sleep Timer
1 Activate the sleep timer mode.
2 Specify the time (in minutes).
To check the time remaining until the shut-off time
• If you press the button repeatedly, you can change the shut-
off time.
CLOCK/
SLEEP
2 sec.
SLEEP
REPEAT1
TRACK WMA
GROUP
HBS JAZZ
CLOCK/
SLEEP
1PRESETy
CLOCK/
SLEEP
1PRESETy
CLOCK/
SLEEP
CLOCK/
SLEEP
SLEEP
2 sec.
10 20 30 40 50
90 80 70 60
CLOCK/
SLEEP
(Canceled)
OFF
CLOCK/
SLEEP
SLEEP
2 sec.
UX-G100[B].BOOK Page 12 Monday, June 30, 2008 6:31 PM