16
4 Confirm the selection.
Next program step is indicated.
5 Repeat steps 3 and 4 to program the other tracks.
6 Start playback.
The tracks you have selected are played back in the order
you have programmed.
• You cannot select the track with the number buttons during
Program Play.
To check the programmed contents
While the PROG indicator lights up on the display and
playback is stopped...
To modify the program
While the PROG indicator lights up on the display and
playback is stopped...
To skip a track: To pause: To stop:
To release, press
again.
DISPLAY/
PROGRAM
MP3
PROG
CD
1PRESETy
CD
STOP
DISPLAY/
PROGRAM
Edit:
1 Press DISPLAY/PROGRAM repeatedly until the
program step you want to edit is displayed.
2 Perform the steps 3 and 4 on page 15 and 16.
To add step in the program:
1 Press DISPLAY/PROGRAM repeatedly until “--” is
displayed.
2 Perform the steps 3 and 4 on page 15 and 16.
To erase entire program:
The PROG indicator goes off.
Program contents are also erased by the following
operations:
• Open the CD door.
• Change the source.
• Turn off the System.
STOP
UX-G100[B].BOOK Page 16 Monday, June 30, 2008 6:31 PM
To Next Page
Loading...
Need help?
General
