UX-J60
(No.22029)1-7
2.1.2 Removing the rear cover
(See Fig.4)
(1) Remove the two screws C attaching the rear cover.
Fig.4
2.1.3 Removing the rear panel / fan assembly
(See Fig.5, 6)
• Prior to performing the following procedure, remove the metal
cover and the rear cover.
(1) Remove the eleven screws D attaching the rear panel. Re-
lease the two joints a on the rear side and the two joints
b on each side.
(2) Remove the two screws E attaching the fan bracket and
release the two joints c on the rear panel, and remove.
(3) Disconnect the wire from the connector CN916 on the main
board.
Fig.5
Fig.6
C
Rear cove
To Next Page
Loading...
