48
English
Timer Play (wake-up play) (continued)
Continued from page
47
(while “PLAY?” is flashing)
6 Press the SET button.
7 Set the function to “CD” or “MD”—whichever disc is to be heard—
and place the MD or CD in position.
8 Turn off the power.
The present time now appears in the display window.
Match the connected receiver or other source with the unit’s setting, and adjust the volume to the
appropriate level. Match the timer with the unit’s timer setting.
•
•
•
Timer play now starts at the programmed start time, and the power is turned off at the programmed
end time.
• Clearing a timer operation
Turn on the power, press the TIMER/CLOCK button, select the timer mode, and press the CANCEL
button.
The DAILY 3 (or ONCE 3) display is cleared, and the timer operation is also cleared.
MD
The timer programming is displayed once,
and then the function display is restored.
CDCD
STANDBY
POWER
STANDBY
POWER
Place the MD to be
heard in position.
Place the CD or CDs to be
heard in position on the CD1,
CD2 and/or CD3 tray.
Lamp lights.
DAILY
This display appears when the
DAILY TIMER play mode is set.
• When “REC?” flashes, turn the jog dial to select “PLAY?” flashing.
• The timer programming is displayed once, and then the function display is restored.
• When MD play is set.
• When CD play is set.
XU-301 MD-CD COMBINATION DECK
REC
PAUSE
REC
START
REC
DIGITAL CD
REC SOURCE SELECTOR
LINE MIC
STOP
MIXING
CANCEL
CD
MD
MIC
MAXMIN
PHONES
MIX BALANCE REC LEVEL
CD
LINE
LINE
MIC
PLAY MODE/CHARA
DISPLAY
TITLEEDIT
32kHz 44.1kHz
DIGITAL INPUT
48kHz
LISTENING
SKIP
1st TRACK
REC
TIMER
/CLOCK
STANDBY
CD REC
SET
2
CD
CD
3
1
CD
PLAY & EXCHANGE
3
-
CD
NORMAL SPEED
CD PITCH CONTROL
POWER
EDIT
8
7
6
SAMPLING RATE CONVERTER
SET
CANCEL
09/p45-49 (E) 4/1/98, 5:09 PM48
To Next Page
Loading...
Need help?
General
