1-7
XV-D721BK
XV-D723GD
Prior to performing the following procedure, remove
the top cover and the fitting.
Disconnect the card wire from connector CN818 on
the regulator board.
Turn back the body and remove the three screws D
fixing the front panel assembly.
Release the two joints c on both sides of the body
and remove the front panel assembly toward the
front.
1.
2.
3.
Removing the front panel assembly
(See Fig.6 to 9)
Fig.6
Fig.7
Fig.8
Fig.9
Regulator board
CN818
Front panel assembly
Front panel assembly
Joint c
Joint c
(Bottom)
DD
To Next Page
Loading...
