29
Initial Settings
DIGITAL OUT
DOWN MIX
COMPRESSION
SCREEN SAVER
AUTO STANDBY
PCM ONLY
OFF
OFF
MODE 1
OFF
PRESS KEY
PREFERENCE1
PREFERENCE2 SPK.SETTING
DIGITAL OUT
DOWN MIX
COMPRESSION
SCREEN SAVER
AUTO STANDBY
PCM ONLY
OFF
OFF
MODE 1
OFF
PRESS KEY
PREFERENCE1
PREFERENCE2 SPK.SETTING
DIGITAL OUT
DOWN MIX
COMPRESSION
SCREEN SAVER
AUTO STANDBY
PCM ONLY
OFF
OFF
MODE 1
OFF
PRESS KEY
PREFERENCE1
PREFERENCE2 SPK.SETTING
DIGITAL OUT
DOWN MIX
COMPRESSION
SCREEN SAVER
AUTO STANDBY
PCM ONLY
OFF
OFF
MODE 1
OFF
PRESS KEY
PREFERENCE1
PREFERENCE2 SPK.SETTING
DOWNMIX
This setting adjusts the signal output to the Audio Output terminal to match the
connected device.
• Lt/Rt: Use this setting if the Audio Output terminal of the player is
connected to a receiver with a built-in Dolby Pro Logic decoder.
• Lo/Ro: Use this setting if the Audio Output terminal of the player is
connected to a TV or a receiver with a built-in Dolby Pro Logic
decoder.
• OFF: Use this setting if the 5.1 ch Audio Output terminal of the player is
connected to a receiver with a 5.1ch input terminal.
COMPRESSION
You can adjust the downmix range according to your needs.
• ON: This plays discs while suppressing the dynamic range. Use this
for quiet films etc. and other discs where is difficult to hear the
audio.
• OFF: This plays discs using the original dynamic range.
SCREEN SAVER
If a still image is displayed for a long time, a residual shadow of the image can
be burnt-into the TV screen. To prevent this from happening, the player has a
screen saver function. If more than five minutes elapses without any operations
being performed, the screen saver starts. You can choose the following settings.
• MODE 1: This mode uses a moving background.
• MODE 2: This mode uses a stationary background.
• DIMMER: This mode dims the screen.
• OFF: The screen saver function is switched off.
Note:
●
If the Screen Saver function is set to OFF, be careful to ensure that image burn-in does not occur.
●
If the Screen Saver function is set to MODE 1 and flickering occurs, change to a different setting.
AUTO STANDBY
When the unit is stopped for more than 30 minutes or 60 minutes, the unit enters standby mode automatically.
• 60: Time is set to 60 minutes.
• 30: Time is set to 30 minutes.
• OFF: The auto standby function is off.
OFF 30 60
XVD9000E_p25-32.p65 2/27/01, 2:38 PM29
To Next Page
Loading...
