Operatingexternalcomponentswith the remote control
I The buttons described below are used on 14 and 15. I
I
pages
DBS
VCR --
Number
buttons
TV RETURN--
ENTER
®®
®®
@®
VCWDBS
0/I VCR/DBS
...... B Oil TV
TW
ill m -- CH +/-
loo+
Remote
control mode
selector
RE(
TV VOL
TVVOL+_
II
(play button)
NOTE
• Manufhcturers' codes are subject to change without notice.
• get the codes again after replacing the batteries of the remote control.
• Tosetthemanufacturer'scode
1 Slide the remote control mode selector
to TV.
2 Press and hold ©/I TV.
Keep the button pressed mrtil step 4 is finished.
3 Press ENTER.
4 Press number buttons (1-9, O) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press l, then 0.
For a Toshiba TV: Press O, then 8.
Manufacturer Code Manufacturer Code
]VC 01" Samsung 12
Hitachi 10 Sanyo 13, 14
Magnavox 02 Sharp 06
Mitsubishi 03 Sony 07
Pmlasonic 04, 11 Toshiba 08
Philips 15 Zenith 09
RCA 05
5
*"0l" is the initial setting.
Release ©/I TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
• Operation
Aim the remote control at the T\(
IMPORTANT
Be_re using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The %llowing buttons are available:
©/I TV: Turns TV on and oK
TV VO k +/-: Adjusts the volume.
TV/VIDEO: Selects the input mode (either TV or
VIDEO).
CH +/-: Changes the channels.
1-10, O,> 10 (100+): Selects the channel.
TV RETURN: Alternates between the previously selected
channel and the current channel.
NOTE
• The operating buttons may difi%rdepending on manuihcturers.
14
To Next Page
Loading...
