Audio Setup Page:
Speaker Setup
Spdif Setup
Speaker Setup Page
Down mix LT/RT
Stereo
5.1
Front Speaker Lrg Large
Small
Center Speaker Sml Large
Small
OFF
Rear Speaker Sml Large
Small
OFF
Subwoofer ON ON
OFF
There are several setup pages discussed in the following
material. In the Audio category, there are two main areas:
Downmix:
Dialog volume:
In LT/RT or stereo output mode, set up this item
to adjust voice, within the range from 0 to 20.
SYSTEM SETUP
SPDIF output:
When you have an external audio system (e.g. a Home Theater
System) that can accept digital audio signals via a coaxial or
optical cable, SPDIF should be turned on (see below). Doing
so enables the digital signals that leave the JD-VD502 to be
processed by Dolby and DTS Home Theater systems, among
many other devices that have internal decoders capable of
RAW decoding.
Select SPDIF/RAW when you have a receiver that can decode
the digital signal internally. SPDIF is the preferred option in
most cases. If you don't hear any output, then switch to
SPDIF/PCM.
Select SPDIF/PCM when the unit is connected to a 2-channel
digital stereo amplifier, or equivalent device, which does NOT
have the ability to decode the signal.
Select SPDIF/OFF if you do not have a receiver capable of
processing digital audio.
SPDIF Setup Page:
SPDIF output RAW SPDIF OFF
SPDIF RAW
SPDIF/PCM
To Next Page
Loading...