E1
When the unit is working, press the setup key to enter setup menu.
Press the direction key " " to move cursor to the desired setup page, and press the Enter key
to confirm.
Press the direction key " " " " to move cursor to the desired setup item, and press the Enter
key to confirm.
Press the direction key " " to return to last Setup item.
Note:
1. Moving to theselected item will produce a relevant list of features at the bottom of the screen.
2. If a selection is "grayed out" it cannot be chosen in the current context.
3. The setup selections remain in effect even when the unit's power is off.
General Audio
Dolby
Video
General Setup introduction:
TV Display
A.Normal/PS: When the unit connects with TV set,
wide image is showed on the whole screen, but a
part is cut.
B.Normal/LB: When the unit connects with TV set,
playing wide image, there are black bands showed
on the up and down screen.
C.Wide: Choose this when the unit connects with
wide screen TV se
D.wide squeeze
t.
Angle Mark: Select display angle, when playing
multi-angle DVD disc.
OSD Language: Select operation language.
Captions:This function is ineffective if no caption
record in the disc. If the caption is closed, press
the caption key on the remote control to open
captions function to select captions language.
S
Hdcd
This setup can adjust to different sampling rates
used by HDCD discs by using multiples of the standard
44.1 KHz sampling rate found on common CDs.
Choose the correct sampling rate for the HDCD disc
being played.
creensaver
When the Screensaver is on, to prevent aging or damage
to the TV's CRT picture tube, if applicable, a floating
picture will be produced for several minutes after the unit
stops playing, preventing a possible "burned-in" image.
General Setup Page
TV Display PS Normal/PS
Normal/LB
Wide
Angle Mark ON ON
OFF
OSD Language English
Captions OFF ON
OFF
Screen saver ON ON
OFF
Hdcd 1x 2x
1x
OFF
SYSTEM SETUP
E
Spanish
nglish
Preference
wide squeeze
To Next Page
Loading...