Symptom
No power
No picture
No sound
Distorted picture
Luminance unsteady
or picture with noise
Unable to play
Key not working
on the remote.
Remote control
does not work
Reason(s)
Power cord not connected to the wall outlet
TV not set up with correct settings
Video cables improperly secured or connected
Audio cables improperly secured or connected
External audio system not turned on
The audio output setting is not correct.
Disc is dirty.
In fastforward or fastbackward mode
Circuitry influence
Do not load disc in
The disc is improperly loaded
The disc is loaded upside down
Disc not loaded properly in the guide slot
Disc dirty
TV screen shows device menu selected
Power wave or other abnormal
phenomenon (such as static) disturbs
the normal condition.
Do not point remote control at the remote
sensor directly.
Remote control is too far from DVD unit.
Batteries are depleted.
Solution(s)
Connect them well
Set up TV in the correct mode
Connect them properly
Connect them properly
Power it on
Set it to the correct mode
Clean the disc or try another one.
Sometimes, a tiny distortion appears, it is a normal
condition.
Connect DVD video player to TV directly
Place disc in
Load a readable disc in (check the disc type)
Replace the disc with the label side up
Load the disc correctly
Clean the disc
Press Setup button to turn off the menu.
Switch on/off power or unplug/replug the power cord.
Point remote control at the remote
Operate remote control within 7 meters (23 ft) of TVs
Replace the batteries and insert with the correct polarity.
Trouble Shooting
F1
SYMPTOM AND SOLUTION:
To Next Page
Loading...