Kaba Saflok QuantumII MT RFID - Testing Lock Functionality

© SAFLOK, all rights reserved.
INS_QTMIIMTRFID_2_12
QuantumII
TM
MT RFID Installation Instructions Pg 7 of 8
Testing Lock Functionality
Pass a Construction key over the QuantumII MT RFID reader. The green light will flash for five seconds. Be sure that the
green light flashes for five seconds while the exterior lever remains operable. If the green lights do not flash, refer to
the table below.
Lock Communication Electronic Function Description
Red and green LEDs flash Time and date not set, use the Quantum MT RFID LPI probe to reset
nine times simultaneously
Yellow LED flashes 12 times Dead bolt is thrown or switch cam is not properly aligned
Yellow LED flashes two times Keycard not allowed OR keycard cancelled by new keycard
Red and green LEDs flash Low battery (contact the SAFLOK service department)
alternately nine times
Yellow and red LEDs flash Bad keycard read or corrupted data (may require new
two times simultaneously keycard)