6
It is necessary to forget any other around network and
make sure the Android or iOS device just connect to
the Wireless network you want to configure.
Make sure the Android or iOS device Wireless function
works well and can be connected back to your original
Wireless network automatically.
User must finish all the steps in 8 minutes after powering on
air conditioner, otherwise you need to power on it again.
There are two ways to finish the network configuration:
Network configuration by Bluetooth scan
Network configuration by select appliance type
Make sure your mobile device has already been
connected to the Wi-Fi network which you want to use.
Also, you need to forget other irrelevant Wi-Fi network
in case it influences your configuration process.
Disconnect the power supply of AC.
Connect the power supply of AC, and continuously press
the “LED DISPLAY” or “DO NOT DISTURB” button seven
times in 10 seconds.
When the AC displays “AP”, it means that the AC Wi-Fi
has already entered into “AP” mode.
To Next Page
Loading...
