Kaiser Baas R20 - In Car Operation

To Next Page

To Previous Page

English

In Car Operation

• Once camera is set up and connected to DC power, the

camera will automatically power on and start recording

when the car is started.

• The car camera requires a class 6 or above Micro SD

card (not included) with at lease 8GB of free space.

• The internal G sensor will register any bumps that could

be accidents and registers them as an “Event”. These

event ﬁles will not be recorded over by regular footage,

these ﬁles need to be manually deleted from your SD

card using the provided management software.

• Event recording can be manually triggered using the

“OK” button during recording.

• Still photos can be taken using the Down button during

recording.

• LDWS (Lane Departure Warning System) will warn the

driver if they are not correctly in their lane. This feature

can be adjusted through the Camera setting.

Note: For more information on the R20 interface please see section

marked “Interface”.