18
EN
MULTIFUNCTION OVEN CONTROL
Oven operation functions are steered through
turning of the rotary handle mode of operation
1 and rotary handle temperature regulator 2
on the control panel 3.
The graphic symbols next to the rotary handles
show the chosen operation modes.
To turn off the oven bring the rotary handle
operating mode 1 and the rotary handle
temperature regulator 2 to position «0».
For more comfort you can use the digital clock
timer 6. It enables you to run the oven in an
automatical, half automatical or manuel cycle.
If the red controlling light lapses it signalizes that
the set oven temperature has been reached.
If a cooking recipe advices you to put the meal in
a preheated oven, o this after the lapse of the red
controlling light.
The red controlling light can also glow when the
rotary handle is in the oven inner allumination
position, but in this rotary handle position the
heating element is always off.
If the control panel of your oven is equipped with
rotary handles Push (sunk rotary handles), for
the control with these rotary handles is necessary:
x Push the rotary handle carefully and let it
go
The rotary handle will come out of the control
panel
To countersink the rotary handle:
x Push the rotary handle as far as it will go
and let go
*
for models with digital time switch clock
1
2
Important! The activation of the oven is
signalizes by the flashing up of controlling
lights in yellow 4 and red 5.
To Next Page
Loading...
Need help?
General
