6
EN
NSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTION
Before connecting the cooking hob to the mains
power supply, make sure that:
x the plant characteristics are such as to
follow what is indicated on the matrix plate
placed at the bottom of the working area,
x the mains supply has an efficient ground
connection complying with all applicable
laws and regulations.
Correct grounding is a legal requirement. If the
appliance is not pre-fitted with a power cable and/or
plug, use only suitable cables and plugs capable of
handling the power specified on the appliance's
data plate and capable of resisting heat. The power
cable should never reach a temperature 50°C
above ambient temperature at any point along its
length.
If the appliance is to be connected directly to mains
terminals, fit a switch with minimum aperture of 3
mm between the contacts. Make sure that the
switch is of sufficient capacity for the power
specified on the appliance's data plate, and
compliant with applicable regulations. The switch
must not break the yellow-green earth wire. The
socket or switch must be easily reachable with the
cooking hob fully installed.
Attention! The manufacturer declines all
responsibility for damage or injury if the
above instructions and normal safety
precautions are not respected.
Attention! Installation and electrical
connection must be made by a qualified
expert only.
To Next Page
Loading...
Need help?
General
