8
EN
GAS CONNECTION
The cooking hob is designed to operate with both
natural gas (methane) and liquid gas (LPG), and
can be easily converted from one type to another
following the instructions given in the relative
section of this booklet «Converting to a different
type of gas».
If the appliance is to operate with gas bottles (LPG),
a pressure regulator conforming to the
requirements.
Rigid pipe connection
Connection to the mains gas supply may be made
via a rigid pipe firmly attached to the fitting 1, or by
means of a hose with a steel tip, conforming to a
maximum length of 2 meters.
It is advisable to tighten the junctions by insulating
teflon tape.
Attention! CHECK UP
LEAKPROOFNESS of the connection to
the gas supply pipe or gas cylinder using
soap suds only. Don’t use open flame –
danger to life!
Attention! Connection to the gas supply
and converting to a different type of gas
must be carried out by qualified technicians
and in conformance with the requirements.
1
To Next Page
Loading...
Need help?
General
