2.
Setting Modbus on Sensedge Mini
A. Set up Modbus via RS-485
To set up Modbus communication, connect your cable from the RS-485 network to a
4-pin Phoenix pin plug. Check the “A” “B” marks on the back of the device to make
sure the cables are connected in the right order, and fasten the screws on the
Phoenix pin plug to secure the cables.
Run the cables through the opening on the plate, and plug the 4-pin Phoenix pin
plug into the corresponding terminals on the back of the device.
The default Modbus address is set as 1, and can be changed later via the Kaiterra
Configuration Tool.
B. Prepare for Configuration
Download the Kaiterra Configuration Tool and install it on your computer.
After the device has been turned on, it will automatically enter the configuration
mode for 15 minutes. The STATUS light will flash in yellow. If your device isn’t in
configuration mode, please turn o the device and turn it back on again.
To Next Page
Loading...
Need help?
General
