You can configure Parity to be odd, even, or none by selecting from the drop
down menu in the Kaiterra Configuration Tool. The default setting for Parity is
“even”.
If your Modbus network does not use parity checking, select “none”. Please
consult your Modbus network admin or BMS admin to confirm the parity type of
your local network. Please note that all devices in the same network should be set
to the same parity type.
Setting AQI
You can choose your AQI standard and customize your AQI calculation in the
Kaiterra Configuration Tool. AQI stands for Air Quality Index, an index calculated
based on the concentration of a set of air pollutants. Sensedge Mini oers AQI
value in the Modbus communication so that you can integrate the information
into your local system.
Choose the AQI standard from the drop down menu in the Kaiterra Configuration
Tool, and select the pollutants used for the AQI calculation. Please note that only
the pollutants monitored by your device can be included in the calculation.
Please consult the facility manager or other responsible personnel if the Modbus
address is not clear.
Click save and disconnect your computer from the “Kaiterra” network.
To Next Page
Loading...
Need help?
General
