Kaiweets 3010DF - Constant Current Mode (C.C. Mode)

Constant Current Mode (C.C. Mode)
Step-by-step illustration on Page III-Ⅳ
(1) Connect the three-wire power cord with a Standard AC outlet.
(2) Turn the Coarse Voltage Regulator clockwise to maximum position and the Coarse Current Regulator and Fine Current
Regulator anti-clockwise to minimum position.
(3) Connect the positive output terminal and the negative output terminal with a wire (one included) and bring it to a short
circuit.
(4) Press the power switch to turn it on. The C.C. indicator lights up, which means it’s on C.C. Mode.
(5) Turn the Coarse Current Regulator and Fine Current Regulator clockwise to that you are desirous of output current value.
(6) Always press the power switch and shut it off before connecting the positive output terminal and negative output terminal
with a load or similar component. Then switch it on.
(7) The output current will be displayed. Voltage can’t be changed in C.C. Mode.
NOTE: The working mode is decided by the load current and the traction current. In Constant Current Mode, the voltage
is determined by the load. The smaller the load, the smaller the voltage.
5