Maintenance
Repair
Do not attempt to repair or service your instrument unless you are qualified to do so and have the relevant calibration,
performance test and service information.
Replacing the Fuse
Turn off the power switch, remove the power line cord from the power socket and disconnect the test leads at output terminals
before replacing the fuse. Replace it only with same type of fuse.
Cleaning
To clean the DC Power Supply, use a soft cloth dampened in a solution of mild detergent and water. Do not spray cleaner
directly onto the device, since it may leak into the cabinet and cause damage. Do not use chemicals containing benzine,
benzene, toluene, xylene, acetone, or similar solvents. Do not use abrasive cleaners on any portion of the power supply.
7
To Next Page
Loading...