Kaiweets HT118E - Safety Instructions; Warning; Safety Operating Procedures; Cautions

English
Safety Instructions
The instrument is designed according to the requirements of the international electrical safety standard IEC61010-1 for
the safety requirements of the electronic testing instruments. The design and manufacture of instruments strictly comply
with the requirements of IEC&1010-1 CAT.IV 600V CAT.III 1000V over-voltage safety standards and pollution level 2
Á\ Warning
In order to avoid possible electric shock or personal injury and other safety accidents, please abide by the
following specifications:
© Read this manual before using the instrument, and pay special attention to safety warning information.
© Check whether the instrument case is damaged.
® Comply with local and national safety code,
Safety Operating Procedures
Remove probe before opening the outer cabinet or battery cover.
Put your fingers behind the finger protector of the probe.
Connect the neutral line or the ground line first, then connect the ive wire.
Disconnect the live wire first, then disconnect the neutral line and ground line.
Replace the battery when it shows low battery indicator.
Cautions
® Don'tuse the instrument around explosive gas, steam or in wet environment
© The instrument is used with specified category, voltage or current rating.
-1-