Kaiweets KM201 - Page 2

Safety Instructions
The design and manufacture of instruments strictly comply with the requirements of IEC61010-1 CAT.I 600V over-voltage safety
standards and pollution level 2.
Warning
/N In order to avoid possible electric shock or personal injury and other safety accidents, please abide by the following
Specifications:
@ Read this manual before using the instrument, and pay special attention to safety warning information.
@ Check whether the instrument case is damaged.
® Comply with local and national safety code.
Safety Operating Procedures
® Remove probe before opening the outer cabinet or battery cover.
@ Put your fingers behind the finger protector of the probe.
® Connect the neutral line or the ground line first, then connect the live wire.
@ Disconnect the live wire first, then disconnect the neutral line and ground
1