Kaiweets KM601s - Capacitance Measurement; Capacitance Measurement Procedure

When the meter probe is incorrectly connected: ~ __ l/ .
Capacitance measurement
1. Press “fue’ button to “IF gear, ‘nF’ signal will be displayed on the screen, indicating
capacitance testing.
2. Insert the red probe into ‘INPUT’ jack and the black probe into the ‘COM’ jack.
3. Touch the meter probe to both ends of the capacitor under test.
4. Read the measurement results from the display.
NOTE:
1. If the measured value is significantly different from the value marked on the capacitor, the
capacitor is damaged.
2. Before measuring the capacitor, discharge the capacitor to avoid damage to the Meter. Do so
by connecting the capacitor to a high-powered resistor.
3. Discharge the capacitor after measurement to avoid any potential safety hazards.
4. If the capacitance is large, it may take a long time for the reading to stabilize.
14