Kaiweets KM602 - Page 11

(3) Press " (s} button to switch AC or DC current measurement
(4) Insert the red probe into A jack and the black probe into the "COM" jack.
(5) Disconnect the measured power supply, connect the meter with the power supply, and then tum on
the measured power supply.
(6) Read the results from the display.
Overload protection: F10A/250V fuse
Response frequency: 40Hz~1kHz, True RMS
Resistance measurement
(1) Long press " ()" button for about 2 seconds to power on, display Auka and enter the intelligent
measurement mode.
(2) Press "[2" button to select "Q" gear. "Q" signal will be displayed on the screen, indicating the
resistance measurement (the resistance value is less than about 5002 The buzzer sounds).
(3) Insert the red probe into "INPUT" jack and the black probe into the "COM" jack
(4) Contact the probe with both ends of the measured resistance.
(5) Read the results from the display.
Overload protection: 250V
Continuity test
(1) Long press " ()" button for about 2 seconds to power on, displayAuta and enter the intelligent
measurement mode
(2) Press "] button to select "’ gear.
10