DCW BedienA Pedelec_RZ5.qxd
Charging the battery
The charging time given in this manual is the time that is necessary for charging after the
capacity of the battery has been used up. This is indicated by the blinking of the battery
charge status LED.
! To avoid shortening the service life of the battery you should not charge the battery
longer than 48 hours.
Removing the battery
In order to charge the battery, you must remove it from the bicycle.
Attention: For reasons of safety you should make sure that you have removed the key.
Charging process
1. Plug the charging device into a 220 volt socket. Grasp the battery and insert it into the
slot provided for it on the charging station.
2. The LEDs of the battery light up. When all 5 LEDs are glowing red, the battery is fully
charged.
3. Remove the battery from the charging station.
4. Unplug the charging station.
1. Hold the battery firmly and open the lock
with the key in an anti-clockwise direction.
2. Tilt the battery slightly to the side.
3. Lift the battery with both hands and
remove it from the holder.
To Next Page
Loading...
Need help?
General
