To Next PageTo Next PageWhat to do if I suspect an air leak in my Kampa Rally Air 200 awning?
If you suspect an air leak in your Kampa Accessories awning, first ensure the inflation valve is properly closed and the black ‘O’ ring seal is in place. Also, check that the top cap on the inflation valve is tightly secured and all deflation valves are closed.
How to fix difficulty in pumping up my Kampa Accessories awning?
If your Kampa Accessories awning is difficult to pump up, make sure the inflation valve is fully screwed into the AirPole and that the dump (deflation) valves are closed. Check that the inflation tube isn't twisted at the valve. If it is, stop inflating and untwist it. Finally, verify that the pump is functioning correctly.
General| Type | Inflatable Awning |
|---|---|
| Width | 200 cm |
| Depth | 250 cm |
| Hydrostatic Head | 6000 mm |
| Air Tubes | Yes |
| Water Column Rating | 6000 mm |
| UV Protection | Yes |
Covers condensation, PU coating, seam sealing, weathering, and operational advice.
Verify all parts are present and choose a flat, wind-protected site.
Slide awning beading into caravan channel, position, and zip panels.
Peg rear/front corners, close deflation valves, secure inflation valve.
Pump air into the awning until AirPoles assume correct shape and feel hard.
Peg out awning in sequence and use guy lines for tension and shape.
Use appropriate pegs for ground type, driving them at a 45° angle away from the point.
Install sealing pads, draught/mud skirts, and operate curtains/blinds.
Attach tie-downs to side release buckles for extra security in strong winds.
Deflate awning, fold, roll, and ensure it's dry before storing.
Un-peg corners, fold inwards, and roll towards valves to expel air.
Ensure awning is totally dry before storing in a cool, dry, dark space.
Main seams are taped; use sealant on remaining seams or damaged tape.
Prolonged sun exposure can weaken fabric; use shaded sites for extended periods.
Do not cook in the awning or use naked flames; read fire precautions label.
Inflate, check valves and hoses, and investigate individual AirPoles for pressure loss.
Remove AirPole carefully, locate puncture, and repair with tape or solution.
Never open grey inner tubes when inflated or if tube is under pressure.
Store awning opened out, fully dry, in a well-ventilated dry place.
Wash with water/soft brush, never detergents. Treat zips with care, use two hands.
Carry silicone waterproof spray, seam sealer, and repair tape for the AirPoles.
Flysheet repairs should be made by Kampa or dealer; unauthorized repairs may void warranty.
Covers manufacturing faults, materials, and parts for 2 years (AirPoles) and 1 year (other components).
Excludes UV degradation, misuse, storm damage, commercial use, and consequential losses.
Check inflation valve, dump valves, twisted tube, and pump functionality.
Ensure isolation valves connecting AirPoles are open.
Check if an isolation valve has been closed and reopen it.
Add more air to straighten kinked AirPoles.
Check valve closure, cap tightness, and deflation valve status.
Main seams are taped; use sealant on remaining seams or damaged tape.
Caravan beading uses waterproof thread that swells when wet ('weathering').
Details on Continental Cushioned Carpet, Easy Tread Carpet, and Inner tent options.
Information on Storm Tie Down kit and Rear Upright Pole Set for stability.
Hanging Rail and Awning Organiser that fit into AccessoryTrack®.
Details on Roof lining for insulation and Breeze Electric Pump for easier inflation.
Photographs/diagrams are for illustration; specifications are approximate and subject to change.
