Do you have a question about the Kampa Rally Series and is the answer not in the manual?
Explains condensation is normal and can be improved by ventilation.
Discusses factory taped seams, optional seam sealant, and thread weathering for water resistance.
For light to moderate weather and touring use; trial run recommended.
Choose a flat, wind-protected site; orient doors away from wind.
Assemble poles and legs, attach awning beading to caravan rail.
Insert roof poles into sleeves, connect to legs, and secure to ground pins.
Peg rear corners first, then front, using diagonal pulling for tension. Adjust leg height.
Use pre-attached guy lines and optional storm tie-down kits for tension and security.
Draught skirt through awning rail; mud skirt with eyelets for ground securing.
Blinds for windows roll up or to the side and secure with tie tapes.
Optional poles, storm kits, seam integrity, UV degradation, and condensation.
Do not cook or use naked flames; read fire precautions label.
Reverse setup procedure; clean parts, dry fully, fold with two people.
Air dry fully before storing in a ventilated dry place; wash with water and soft brush.
Addresses issues like pulling the awning close, sagging, or movement along the rail.
Addresses leaks due to condensation, seam issues, or beading.
Creates an enclosed area in front of the awning.
Breathable groundsheet and rear upright poles for better seal.
Offers protection/privacy; tie down kits for extra security in bad weather.
Stops awning movement in rail; poles provide extra roof support.
| Category | Awning |
|---|---|
| UV Protection | Yes |
| Material | Polyester |
| Weight | Varies by size |
| Pack Size | Varies by size |












Loading...