Kampa Rally 200 User Manual

Rally
200, 260, 330 & 390
Instructions & care manual
The Rally is a registered design exclusive to Kampa UK Limited
Some of the images shown in these instructions are other similar
Kampa awnings and are for illustration purposes only.
Rally 330 Pearl Grey
2
IMPORTANT - PLEASE READ:
Under certain conditions all awnings will suffer from internal condensation.
Depending upon the atmospheric conditions, the weather and the amount of
moisture in the ground, the condensation could be quite severe and is
commonly mistaken for leaking, especially as it can run down the inside of the
roof and drips off ties tapes and other internal fittings. If you suspect your
awning is leaking it is almost certainly condensation. Laying a waterproof
groundsheet (not a breathable carpet) throughout the whole awning will help
and condensation can also be improved by ensuring adequate ventilation. On
some awnings we offer an optional roof lining that can also help prevent
condensation and catch any drips of condensation that fall from the roof.
The awning material has a waterproof PU coating over its entire surface and
the main seams of your awning have been factory taped to help prevent
leakage. Depending upon your expectations, it may be necessary to treat the
remaining seams with a seam sealant. Seams treated with seam sealant
cannot leak. Seam sealant should also be applied to areas where the taping is
damaged or has peeled away through wear and tear. It can also be applied to
areas where a leak may have developed. Seam sealant is available from your
dealer.
The awning beading is sewn to the awning with a special waterproof sewing
thread. This thread swells when wet to fill the needle holes but thread needs
to become wet several times before it is totally effective. This process is known
as ‘weathering’ and it may take several soakings for the weathering to be fully
effective. This area can also be treated with seam sealant.
WELCOME
Thank you for purchasing your Kampa awning. Please read these
instructions carefully before attempting to set up your awning and retain for
future reference. If used properly, your awning should give you years of
trouble free use. We recommend that your awning is insured against
accidental and storm damage as this is not covered by the warranty.
This awning is designed for use in light to moderate weather. During strong
winds or snowfall we recommend that you take your awning down. The
awning is designed for touring use; it is not designed for static or commercial
use.
We recommend a trial run before using your awning for the first time. This will
allow you to familiarise yourself with the awning, its set up and any limitations
the awning may have for your particular use. Please also check your caravan
awning rail to ensure that it is not damaged or has any sharp edges that could
damage your awning.

Kampa Rally 200 Specifications

General

Brand	Kampa
Model	Rally 200
Category	Accessories
Language	English

Summary

Important Information and Setup Preparations

Condensation Management

Explains internal condensation, how it's mistaken for leaks, and prevention methods like groundsheet and ventilation.

Waterproofing and Seam Treatment

Details the awning's PU coating, factory-taped seams, and use of seam sealant for leaks.

Thread Weathering

Awning Suitability and Usage

Site Selection

Initial Setup Steps

Recommends laying a groundsheet, unpacking, and identifying parts before setup.

Inserting Awning Beading

Guides on sliding the awning beading through the caravan awning channel to the correct position.

Assembling Poles

Instructions for assembling Dynaflex roof poles and Dynasteel leg poles with adjustable feet.

Connecting Poles to Awning

Details on pushing roof poles into sleeves, connecting steel legs, and securing them to awning pins.

Advanced Setup and Accessories

Attaching Clips and Stretcher Poles

Instructions for attaching awning clips to leg poles and inserting aluminium stretcher poles for tension.

Pegging the Awning

Guidance on pegging rear and front corners, adjusting legs, and creating diagonal tension for a taut awning.

Pegging Best Practices

Using Guy Lines

Recommends using pre-attached guy lines for tension, adjusting them, and securing them with pegs.

Sealing Bumper Pads and Upright Poles

Fitting the Draught Skirt

Rally 200 Monsoon Pole

Optional Monsoon Poles

Seam Sealant Application

Storm Tie Down Kit

Safety and Maintenance

Fire Safety Warning

Crucial warning against cooking or using naked flames inside the awning and to read fire precautions label.

Dismantling Procedure

Folding the Awning

Step-by-step guide for two people to fold the awning correctly for packing into the carry bag.

Awning Storage

Cleaning Instructions

Pole Care and Corrosion Prevention

Troubleshooting Common Issues

Provides solutions for common problems like awning fit, sagging, and movement along the rail.

Water Leak Solutions

Specific Water Leak Points