How to fix incorrect output value on Kanomax ANEMOMASTER Measuring Instruments?
To fix an incorrect output value on your Kanomax Measuring Instruments, confirm that the analog output setting is correct and confirm that the output range setting is correct. The load impedance may be set lower than the defined value. (Load impedance: 5k? or higher)
Why does my Kanomax ANEMOMASTER display “E--0”?
If the Kanomax Measuring Instruments displays “E--0” on the screen, the batteries may be low. Turn the power OFF and replace the batteries.
What to do if nothing appears on the screen after new batteries are installed in my Kanomax Measuring Instruments?
If nothing appears on the screen of your Kanomax Measuring Instruments after installing new batteries, the batteries may be installed with incorrect polarity. Turn the power OFF and install the batteries correctly.
Why does nothing appear on the screen when the power is turned ON on my Kanomax ANEMOMASTER?
If nothing appears on the screen when the power is turned ON for your Kanomax Measuring Instruments, the batteries may be low. Turn the power OFF and replace the batteries.
What does it mean when my Kanomax ANEMOMASTER Measuring Instruments displays “E--2”?
If the Kanomax Measuring Instruments displays “E--2” on the screen, it could be due to a low battery or the printer head overheating from continuous use. Turn the power OFF and replace the batteries. If that doesn't work, stop printing temporarily and allow the printer to cool.
What to do if I am experiencing output failure with my Kanomax ANEMOMASTER?
If you are experiencing an output failure with your Kanomax Measuring Instruments, confirm that the polarity of the output terminal is correct, and confirm that normal measurement mode is selected.
What causes data transfer failure in Kanomax ANEMOMASTER Measuring Instruments?
If you are experiencing a data transfer failure with your Kanomax Measuring Instruments, ensure that you are using communication cable exclusively for this model. Also, check the settings of the ANEMOMASTER and the computer for the correct baud rate. Finally, confirm that the communication command is correct.
Why does my Kanomax ANEMOMASTER only print the value shown on the display?
If only the value shown on the display is printed out from your Kanomax Measuring Instruments, single parameter output mode is activated in the data output setting. Switch to all parameters output mode in the function setting.
Why does my Kanomax ANEMOMASTER display a reading as “----”?
If the reading is displayed as “----” on the Kanomax Measuring Instruments, the measurable range may be exceeded, so use the instrument within the specified measurement range. Also, check the probe connection. If the issue persists, the probe/probe cable wire may be disconnected or the sensor is damaged.
Why is the air temperature reading high on my Kanomax ANEMOMASTER?
If the air temperature reading is high on your Kanomax Measuring Instruments, correct readings cannot be obtained when there is no airflow. A minimum of 0.1m/s velocity is required for measurement.
General| Operating Temperature | 0 to 50 °C |
|---|---|
| Storage Temperature Range | -20 to 60 °C |
| Probe Length | 300 mm |
| Resolution | 0.01 m/s |
| Response Time | 1 s |
| Display | LCD |
| Weight | 300 g |
| Functions | Velocity, Temperature |
To Next Page