Kantronics KPC-2 - Watch Dog Timers

COMMANDS
29
MResp ON | OFF V 2.70
default OFF KPC-1/KPC-2/KPC-2400 Packet
default OFF/OFF KAM/KPC-4 Packet
When ON, monitored packets include the following AX.25 response packets, if MONITOR and
MCOM are ON. If connected, MCON must also be ON. The bracketed information will appear at the
end of the header information. The < and << characters are used to bracket and denote packets
received as version 1 or version 2, respectively. For example, <<RR1>> denotes a version 2 pack-
et. In addition upper case characters are used to designate commands (polls) and lower case char-
acters are used to denote responses for RR, REJ and RNR. For example, <<rr1>> is a response in
version 2.
<FRMR> Frame Reject
<REJr> Reject, r = received sequence number
<RNRr> Device busy, r = received sequence number
<RRr> Receive Ready, r = received sequence number
In addition, the following bracketed information will be added to the Information packets as appro-
priate:
<Isr> Information frame (connected);
s = send sequence number, r = received sequence number
See also: ax25l2v2, mcom, monitor
MRPt ON | OFF
default ON KPC-1/KPC-2/KPC-2400 Packet
default ON/ON KAM/KPC-4 Packet
This command affects the way monitored packets are displayed. If ON, the entire digipeat list is
displayed for monitored packets and the station that relayed the packet is indicated with an aster-
isk. The MONITOR command must be ON for this command to work and if connected, MCON must
also be ON. If OFF, only the originating station and the destination station callsign are displayed
for monitored packets.
See also: monitor
MStamp ON | OFF
default OFF All Units Packet
This command enables time stamping of monitored packets. The date and time information is then
available for use for automatic logging of packet activity or other computer applications. The date
and time are set initially by the DAYTIME command and the date format is determined by the
DAYUSA command. The MONITOR command must be ON for this command to work and if con-
nected, MCON must also be ON.
See also: cstamp, daytime, monitor