COMMANDS
44
RETry n (n = 0 – 15)
default 10
KPC-1/KPC-2/KPC-2400
Packet
default 10/10
KAM/KPC-4
Packet
This command specifies the number of packet retries. Packets are re-transmitted n times before
the operation is aborted. The time between retries is specified by the command FRACK.
See also: ax25l2v2, frack, relink, tries
RIng ON | OFF
Default ON All Units Packet/KA-NODES/PBBS
When ON, three bell characters ($07) are sent to the terminal with each ***connected to mes-
sage when another station initiates the connect.
RNrtime n (n = 0 – 255) V 2.85
default 0 All Units Packet/KA-NODES/PBBS
RNRTIME is set in 10 second increments. If a connection stays in a remote device busy state (con-
tinues to receive RNR frames) for RNRTIME, the TNC will disconnect. If a KA-NODE connection
stays in a remote device busy for RNRTIME the KA-NODE will disconnect the input and output
sides of the KA-NODE circuit. Setting RNRTIME to 0 disables this function.
See also: mresp
RTExt text V 5.0
default
blank
KAM
?????
Rtty [n] (n = 20 – 500]
immediate KAM RTTY
This command places the TNC in RTTY Mode. The parameter n sets the transceiver baud rate. If n
is not specified , the baud rate specified in RBAUD is used.
See also: autostrt, canline, pmode, rbaud
SCreenl n (n = 0 – 255)
default 0 All Units All Modes
This value is used to properly format what is sent to your terminal. A <CR> sequence is sent to
the terminal at the end of a line when n characters have been printed. A value of zero inhibits this
action.
See also: autolf
To Next Page
Loading...
